top of page

How to Increase Endometrial Thickness: What Works and How Long It Takes

15 minutes ago
9 min read

Quick answer: How to increase endometrial thickness depends on why your lining is thin. The steps with the best evidence are finding the cause (scarring, polyps, infection, long-term birth control), adjusting estrogen dose, route or length, choosing a natural cycle for frozen transfer, and, if the lining stays under 7 mm, adding treatments such as intrauterine PRP, G-CSF or low-dose aspirin. The lining grows over 10 to 14 days, not 2, and new data on more than 30,000 frozen transfers shows thickness predicts success less than most people think.


In this article


How to increase endometrial thickness: the plan at a glance


Most women with a thin lining can raise it, or get pregnant anyway, by working through a few steps in order. The plan below starts with what is cheapest and best proven, then adds treatments only if they are needed.


Your endometrium is the inner lining of the uterus, the layer an embryo implants into. It thickens under estrogen in the first half of the cycle and is measured by ultrasound before an embryo transfer or IUI. A thin endometrium is usually defined as 7 mm or less, according to a 2024 review in Frontiers in Endocrinology, and it affects about 2 to 3% of fertility treatment cycles.


  1. Measure at the right time. Thickness is checked late in the estrogen phase, just before ovulation or progesterone starts.

  2. Look for a cause. A saline sonogram or hysteroscopy can find scar tissue, polyps or fibroids.

  3. Adjust estrogen. Change the dose, the route (pills, patches or vaginal tablets) or how many days you take it.

  4. Consider a natural cycle. For a frozen transfer, a cycle using your own ovulation can work as well or better.

  5. Add a targeted treatment. If the lining is still thin, discuss intrauterine PRP, G-CSF or aspirin.

  6. Transfer the best embryo. A tested, normal embryo can still implant in a lining just under 7 mm.


Step

What it involves

Typical time it takes

Ultrasound check

Measure the lining late in the estrogen phase

1 visit

Find the cause

Saline sonogram or hysteroscopy

1 to 3 weeks

Adjust estrogen

New dose, route or longer course

1 cycle (about 2 to 3 weeks)

Natural cycle FET

Track your own ovulation instead of medication

1 cycle

PRP, G-CSF or aspirin

Added to the next preparation cycle

1 to 2 cycles


If you're preparing for a frozen embryo transfer, the same steps apply, and your doctor can build them into your transfer calendar.


Step 1: measure it correctly and find the cause


The first step in increasing endometrial thickness is making sure the number is real and finding out why it is low. Treatment works best when it targets the cause.


When and how the lining is measured

The lining is measured on a transvaginal ultrasound as the thickest point from one side to the other. It changes day by day, so a reading taken too early in the cycle can look thin when it is still growing. Ask which cycle day the measurement was taken and whether it will be repeated.


Common causes of a thin uterine lining

The 2024 review lists uterine adhesions, polyps, endometriosis, fibroids and chronic endometritis (a low-grade infection of the lining) among the causes. It also names long-term oral contraceptive use and ovulation-promoting drugs as definite factors. That matches what patients ask in search: "thin uterine lining after birth control", "thin uterine lining after D&C", "does letrozole thin uterine lining" and "does Clomid thin uterine lining".


  • Scarring (Asherman syndrome): often after a D&C or uterine surgery. A hysteroscopy can find and remove adhesions.

  • Polyps or fibroids: can distort the lining. A saline sonogram or HyCoSy maps the cavity.

  • Chronic endometritis: treated with antibiotics. Our reproductive immunology team can test for it.

  • Medication effects: Clomid in particular can thin the lining in some women, and switching medication or protocol can help.

  • Low blood flow or low estrogen response: addressed in steps 2 and 3.


If you had an HSG test recently, bring the report, since it also shows the shape of the uterine cavity.


Step 2: adjust estrogen and cycle type


Changing how estrogen is given, or skipping medicated preparation altogether, is usually the first treatment to try. These changes are simple, inexpensive and add little time.


Estrogen dose, route and length

In a medicated (programmed) cycle, the lining is built with estradiol pills, patches or vaginal tablets. Doctors may raise the dose, switch to the vaginal route or extend the estrogen phase by several days to give the lining more time. The 2024 review notes that the role of estrogen in thickening the lining "remains controversial" and that dosing and route still need standardizing, so this is a reasonable first step rather than a guaranteed fix.


Natural cycle frozen embryo transfer

A natural cycle uses your own ovulation and your own hormones instead of medication. In a 2025 Human Reproduction study of 30,676 transfers of tested, chromosomally normal embryos, a lining under 7 mm lowered the odds of live birth by 22% in programmed cycles and by 41% in modified natural cycles. In true natural cycles, there was no thickness threshold at which live birth rates fell.


If your periods are regular, ask whether a natural cycle FET fits you. At Aurea, we offer natural and medicated preparation, and outside monitoring lets you have scans near home.


Step 3: treatments that add thickness when the lining stays thin


When the lining stays under 7 mm despite estrogen changes, three treatments have the most trial evidence: intrauterine PRP, G-CSF and low-dose aspirin. Each is used alongside, not instead of, a well-timed transfer cycle.


Intrauterine PRP (platelet-rich plasma)

PRP is made from your own blood, concentrated so it carries more platelets and growth factors, then placed into the uterus a few days before transfer. A 2024 meta-analysis of 8 randomized trials with 678 women found that PRP raised the lining by an average of 1.23 mm and roughly doubled the clinical pregnancy rate (RR 2.04). The authors call it possibly "effective and safe" and ask for larger trials.


G-CSF (granulocyte colony-stimulating factor)

G-CSF is a growth factor drug given into the uterus or by injection. The 2024 review says it has "a favorable effect on endometrial thickening," but larger trials are still needed.


Low-dose aspirin and sildenafil

Low-dose aspirin may improve blood flow to the uterus. In one randomized study it improved pregnancy rates in women with a thin lining having IUI, but it did not significantly increase thickness. Vaginal sildenafil has been tested too, with mixed results, so it is used less often.


What about foods, supplements and acupuncture?

Patients often search for supplements, foods, yoga or castor oil packs. None of these has strong trial evidence for thickening the lining. Good general health still matters, so stopping smoking and keeping a healthy routine are sensible, but they should not delay the medical steps above.


What the research shows about how to increase endometrial thickness


The research shows two things at once: a very thin lining does lower the chance of pregnancy, but most linings near 7 mm still give reasonable results, and several treatments can add about 1 mm.


The largest single study, published in Human Reproduction in 2018, looked at more than 40,000 embryo transfers in Canada. In frozen transfers, the live birth rate was 28.4% with a lining of 8 mm or more, 27.4% at 7 to 7.9 mm, 23.7% at 6 to 6.9 mm and 15.0% at 5 to 5.9 mm. The authors noted that "reasonable outcomes were obtained even with lower endometrial thickness measurements."


A 2014 meta-analysis in Human Reproduction Update of 22 studies found a lining of 7 mm or less in only 2.4% of cycles, with clinical pregnancy at 23.3% versus 48.1% above 7 mm. Even so, the authors concluded that thickness "has a limited capacity to identify women who have a low chance to conceive," and that using it alone to cancel a cycle or freeze all embryos "seems not to be justified."


Lining thickness (frozen transfer)

Live birth rate

Source

8 mm or more

28.4%

Human Reproduction 2018

7 to 7.9 mm

27.4%

Human Reproduction 2018

6 to 6.9 mm

23.7%

Human Reproduction 2018

5 to 5.9 mm

15.0%

Human Reproduction 2018


On treatments, a 2025 network meta-analysis of 18 randomized trials and 2,152 women compared six options. G-CSF added about 1.12 mm, aspirin about 1.05 mm and PRP about 0.99 mm, and PRP ranked best for clinical pregnancy. The authors also point out that many trials were not blinded and that no single therapy consistently improves outcomes yet.


Thin vs thicker endometrium cross-section: glands, spiral arteries and layers, showing how to increase endometrial thickness

Can you increase endometrial thickness in 2 days?


No. You cannot meaningfully increase endometrial thickness in 2 days. The lining grows under estrogen over roughly 10 to 14 days, and most treatments in the research were started at the beginning of a cycle or several days before transfer.


"How to increase endometrial thickness in 2 days" is searched about 90 times a month in the US, and some clinic pages promise quick fixes. The top results don't say what the evidence actually supports, and they don't mention the newest data. Here is what you can do on a short timeline:

  1. Ask whether to wait a few days. If you're mid-cycle on estrogen, extending the estrogen phase by several days is often the fastest real gain.

  2. Ask whether the measurement can be repeated. A second scan a few days later can show the lining has caught up.

  3. Discuss transferring anyway. Based on the 2025 euploid study, a lining between 6 and 7 mm with a tested embryo may still be a reasonable transfer, especially in a natural cycle. This is a decision to make with your doctor.

  4. Plan the next cycle instead. If the lining is well under 6 mm, freezing and preparing a new cycle with a different approach often gives a better result than rushing.


That's the honest answer: the fix happens over a cycle, not over a weekend. The upside is that one well-planned cycle is usually enough to know whether the change worked.


How to prepare: tests, costs and questions for your doctor


Preparing well means arriving with your measurements, knowing what the next tests cost, and having clear questions. Aurea's transparent pricing makes it easier to plan.


At Aurea Fertility Center, New York's first AI-integrated fertility clinic, each step is priced up front (prices as of 2026 and can change; your consult confirms the plan):


Service

Price at Aurea

Physician consult

$350 (free 20-minute nurse call)

SIS/HyCoSy (cavity and tube check)

$350

Hysteroscopy

$3,400

Frozen embryo transfer

$4,750

PGT per embryo

$950


Testing embryos with PGT-A matters here, because the 2025 study's findings apply to transfers of a euploid embryo. Our lab grows embryos in an EmbryoScope time-lapse incubator, so you know which embryo is ready when your lining is.


Illustration of an embryo above a thick uterine lining, the goal of thin uterine lining treatments

Questions to ask at your next appointment:

  • What was my lining on which cycle day, and will you measure it again?

  • Have we ruled out scarring, polyps and chronic endometritis?

  • Could a natural cycle FET work for me?

  • Can we change my estrogen dose, route or length before trying add-ons?

  • If my lining stays under 7 mm, would PRP, G-CSF or aspirin make sense, and what do they cost?


Timing questions come up too. Our guide to how many days after egg retrieval embryo transfer happens explains fresh and frozen timelines, and preparing for embryo transfer naturally covers the weeks before. If you're over 40 or have had several failed transfers, our sister clinic Rejuvenating Fertility Center specializes in complex cases.


Frequently asked questions


How can I increase my endometrial thickness quickly?

The fastest real gain usually comes from extending the estrogen phase by several days or changing the estrogen route, such as adding vaginal estradiol. True thickening still takes days to weeks, so ask your doctor whether waiting a few days or planning the next cycle makes more sense.


What is considered a thin uterine lining?

Most fertility specialists call a lining of 7 mm or less thin, measured late in the estrogen phase. It is found in about 2 to 3% of treatment cycles, and many women with a lining near 7 mm still get pregnant.


Can you get pregnant with a thin uterine lining?

Yes. In a 2018 study of frozen transfers, the live birth rate was still 23.7% with a lining of 6 to 6.9 mm. The chance falls more below 6 mm, which is when treatment to increase thickness matters most.


Does PRP increase endometrial thickness?

It can. A 2024 meta-analysis of 8 randomized trials found intrauterine PRP added about 1.23 mm and roughly doubled the clinical pregnancy rate in women with a thin lining, though the authors call for larger trials.


How to increase endometrial thickness for IVF?

Start by checking for scarring, polyps or infection, then adjust estrogen dose, route or length, or try a natural cycle for frozen transfer. If the lining stays thin, PRP, G-CSF or low-dose aspirin can be added in the next cycle.


Does birth control cause a thin uterine lining?

Long-term oral contraceptive use is a recognized cause of a thinner lining, according to a 2024 review. The lining usually recovers after stopping, and your doctor can check it with an ultrasound before treatment.


The bottom line


A thin lining is common, fixable in many cases, and less decisive than it sounds. The best way to increase endometrial thickness is to find the cause, adjust estrogen or cycle type, and add PRP, G-CSF or aspirin only if the lining stays under 7 mm. With a tested embryo and a well-planned cycle, many women with a thin lining still get pregnant.


If you'd like a plan for your lining and your next transfer, book a free 20-minute nurse call or a $350 physician consult with Aurea Fertility Center. We'll review your scans and build a gentle, personalised plan, with a physician approving every step.

Comments


bottom of page